Être un travailleur IT, est-ce que vous vous souciez encore pour passer le test Certificat IT? Le test examiner les techniques et connaissances professionnelles, donc c'est pas facile à réussir. Pour les candidats qui participent le test à la première fois, une bonne formation est très importante. Pass4Test offre les outils de formation particulier au test et bien proche de test réel, n'hésitez plus d'ajouter la Q&A au panier.
Pour l'instant, vous pouvez télécharger le démo gratuit de Q&A Cisco 100-101 dans Pass4Test pour se former avant le test Cisco 100-101.
Le Pass4Test est un site qui peut offrir les facilités aux candidats et aider les candidats à réaliser leurs rêve. Si vous êtes souci de votre test Certification, Pass4Test peut vous rendre heureux. La haute précision et la grande couverture de la Q&A de Pass4Test vous aidera pendant la préparation de test. Vous n'aurez aucune raison de regretter parce que Pass4Test réalisera votre rêve.
On peut télécharger quelques parties de Q&A gratuites dans le site Pass4Test à propos de test Certification Cisco 100-101. Vous pouvez tester notre fiabilité via le démo. Choisir Pass4Test, c'est-à-dire que vous êtes proche d'un pic ensuite de l'Industrie IT.
Code d'Examen: 100-101
Nom d'Examen: Cisco (CCNA Interconnecting Cisco Networking Devices 1 (ICND1))
Questions et réponses: 102 Q&As
100-101 Démo gratuit à télécharger: http://www.pass4test.fr/100-101.html
NO.1 Refer to the exhibit.
HostX is transferring a file to the FTP server. Point A represents the frame as it goes toward the
Toronto router. What will the Layer 2 destination address be at this point?
A. abcd.1123.0045
B. 192.168.7.17
C. aabb.5555.2222
D. 192.168.1.1
E. abcd.2246.0035
Answer: E
certification Cisco 100-101 100-101 examen
Explanation:
For packets destined to a host on another IP network, the destination MAC address will be the LAN
interface of the router. Since the FTP server lies on a different network, the host will know to send
the frame to its default gateway, which is Toronto.
NO.2 Which three statements are true about the operation of a full-duplex Ethernet network?
(Choose three.)
A. There are no collisions in full-duplex mode.
B. A dedicated switch port is required for each full-duplex node.
C. Ethernet hub ports are preconfigured for full-duplex mode.
D. In a full-duplex environment, the host network card must check for the availability of the network
media before transmitting.
E. The host network card and the switch port must be capable of operating in full-duplex mode.
Answer: A,B,E
Cisco certification 100-101 100-101 100-101
NO.3 Refer to the exhibit.
The host in Kiev sends a request for an HTML document to the server in Minsk. What will be the
source IP address of the packet as it leaves the Kiev router?
A. 10.1.0.1
B. 10.1.0.5
C. 10.1.0.6
D. 10.1.0.14
E. 10.1.1.16
F. 10.1.2.8
Answer: E
Cisco examen 100-101 100-101 examen certification 100-101
Explanation:
Although the source and destination MAC address will change as a packet traverses a network, the
source and destination IP address will not unless network address translation (NAT) is being done,
which is not the case here.
NO.4 Which layer of the TCP/IP stack combines the OSI model physical and data link layers?
A. Internet layer
B. transport layer
C. application layer
D. network access layer
Answer: D
certification Cisco certification 100-101 certification 100-101 100-101 examen
Explanation:
The Internet Protocol Suite, TCP/IP , is a suite of protocols used for communication over the internet.
The TCP/IP model was created after the OSI 7 layer model for two major reasons. First, the
foundation of the Internet was built using the TCP/IP suite and through the spread of the World
Wide Web and Internet, TCP/IP has been preferred. Second, a project researched by the
Department of Defense (DOD) consisted of creating the TCP/IP protocols. The DOD's goal was to
bring international standards which could not be met by the OSI model. Since the DOD was the
largest software consumer and they preferred the TCP/IP suite, most vendors used this model rather
then the OSI. Below is a side by side comparison of the TCP/IP and OSI models.
TCP/IP Model VS. OSI Model Application Layer 7 Application Layer 6 Presentation Layer 5 Session
Transport Layer 4 Transport Internet Layer 3 Network Network Access Layer 2 Data Link Layer 1
Physical
NO.5 Refer to the exhibit.
If host A sends an IP packet to host B, what will the source physical address be in the frame when it
reaches host B?
A. 10.168.10.99
B. 10.168.11.88
C. A1:A1:A1:A1:A1:A1
D. B2:B2:B2:B2:B2:B2
E. C3:C3:C3:C3:C3:C3
F. D4:D4:D4:D4:D4:D4
Answer: E
certification Cisco 100-101 100-101 certification 100-101 100-101
Explanation:
When packets transfer from one host to another across a routed segment, the source IP address
always remains the same source IP address, and the source physical (MAC) address will be the
existing router's interface address. Similarly, the destination IP address always remains the same
and the destination physical (MAC) address is the destination router's interface address.
NO.6 Which protocol uses a connection-oriented service to deliver files between end systems?
A. TFTP
B. DNS
C. FTP
D. SNMP
E. RIP
Answer: C
Cisco examen 100-101 100-101 examen 100-101 100-101
Explanation:
FTP is an acronym for File Transfer Protocol. As the name suggests, FTP is used to transfer files
between computers on a network. You can use FTP to exchange files between computer accounts,
transfer files between an account and a desktop computer, or access online software archives
NO.7 Which OSI layer header contains the address of a destination host that is on another network?
A. application
B. session
C. transport
D. network
E. data link
F. physical
Answer: D
Cisco certification 100-101 certification 100-101 100-101 examen 100-101 examen 100-101 examen
Explanation:
Only network address contains this information. To transmit the packets the sender uses network
address and datalink address. But the layer 2 address represents just the address of the next hop
device on the way to the sender. It is changed on each hop. Network address remains the same.
NO.8 Refer to the exhibit.
If the hubs in the graphic were replaced by switches, what would be virtually eliminated?
A. broadcast domains
B. repeater domains
C. Ethernet collisions
D. signal amplification
E. Ethernet broadcasts
Answer: C
Cisco certification 100-101 100-101 examen 100-101
Explanation:
Modern wired networks use a network switch to eliminate collisions. By connecting each device
directly to a port on the switch, either each port on a switch becomes its own collision domain (in
the case of half duplex links) or the possibility of collisions is eliminated entirely in the case of full
duplex links.
Passer le test Cisco 100-101, obtenir le Passport peut améliorer la perspective de votre carrière et vous apporter plus de chances à développer votre boulot. Pass4Test est un site très convenable pour les candidats de test Certification Cisco 100-101. Ce site peut offrir les informations plus nouvelles et aussi provider les bonnes chances à se former davantage. Ce sont les points essentiels pour votre succès de test Certification Cisco 100-101.
没有评论:
发表评论